This display allows you to store your Speed Champions models in an efficient way. The displays are infinitely stackable and easy to disassemble or add more if needed.
It is assembled without glue, so achieving the correct tolerances is key for stability. Printing outside walls first usually helps. Print the base and spacer as is then depending on your settings you can change the horizontal expansion on the pins to achieve a stable but removable press-fit. All models should be printed in the default orientation.
The display is tested with all the cars shown in the picture, but all 8 and 9-stud wide cars should fit as well. The Dodge dragster also fits on 2 displays next to each other. The Ford Bronco only fits at the top.
The wheelbase is adjustable between 6 and 18 (updated from 16) studs. The pins on the wheel holders fit into the grooves on the base. The cars' wheels fit in the arcs on the wheel holder so they can't roll and are held in place. There is a second variant with continuous wheel arcs if you want to display some older 6-stud wide cars or any MOCs.
The base has 2 variants: one with a built-in brim at the hole and one without it. The wall is thin around the hole so if you have problems with bed adhesion print the one with a brim, then cut it away after. There are also 2 types of pins: the shorter one is used for the top and the bottom, the longer one is used for the connections in the middle.
The author marked this model as their own original creation.