Electric Screwdriver Stand w/Charger and Bits Holder

Inspired by my ADHD, comes an answer to the question “Where the $%&# did I put the screwdriver/charger/bit/screw? IT WAS RIGHT HERE LIKE 30 SECONDS AGO!”.

With this model you can organize them neatly all in one spot, and comfortably misplace them all at once!

This stand can hold a battery-powered mini-screwdriver the likes of WOWSTICK/JAKEMY, at a comfortable angle to allow an ergonomic pick-up and put-down experience, keeping close at hand, and to avoid having it rolling off the table into its doom. 

Has space to hold 3 screw bits and a little tray for screws (with space for a magnet insert up to 25mm x 10mm to keep them there). In the case of the JAKEMY tool that uses an external universal battery charger (Li-ion 21700 18650 14500), it can also hold said charger. For the WOWSTICK with an internal battery you can use this as an extra tray to organize other small tools bits or screws.

The screwdriver fits snuggly by design, with some less tolerant printers you may need to lightly file the inside of the hole to make it fit without sticking too much (use a rounded profile file)

SLICING (0.4mm nozzle): 

• 0.20mm layers
• 2 vertical walls
• 3 top/bottom layers
• 10% triangular infill
• (Optional but recommended) Layer height modifier from 23.48mm to 24.48mm for 25% triangular infill for better support of the bit holes if your printer hates bridges and to avoid loose internal extrusions.
• Also recommend some support for the topside of the magnet insert for the same reason stated above

Any and all good advice and feedback is welcome, I'm still a novice at 3D design and printing and I'm sure improvements can be made to the design, feel free to remix as you see fit!