This is a great looking case, but I'd like to make some modifications for my application. Would it be possible to share the STEP files for your design which are easier to modify in CAD?
Lilygo T5 4.7 S3 E-paper display case
Case and stand for the Lilygo T5 4.7 S3 E-paper display
16
295
3
1811
updated
April 20, 2024
Makes
Comments
Great design. I needed to shave off less than 0.5 millimeters to fit the pcb in properly, but that is probably some tolerance issue of the 3d printer.
Nice design. The wall hanging hole+slots are a nice detail. If you added a 3rd hole+slot at a right angle to the line of the other 2 and added another slot to the leftmost hole, you would extend the utility of your case. This would allow it to be wall mounted in either landscape, with the USB to the right or portrait, with the USB facing down. (edited)
Hello, could you make the back part 2 or 3 mm deeper? My board has a connector (GPIO) and does not allow to fit properly in your design. I will appreciate it! It's a neat and great design.
