Fidget cube - 100% printed

This Thing is licensed under the Creative Commons - Attribution - Non-Commercial - ShareAlike license. This means to share with other people you MUST give appropriate credit and a link to this page. YOU MAY NOT SELL this design, and if you remix this you must use the same license.

Sorry, I just want to make sure people follow the licenses :)

I designed this fidget cube from scratch in Tinkercad, you can also find it there!

Also sorry for the bad camera quality

Post-Printing

Once done, snap the wheel in. Then take the LONGER axle, slide it through the gears, and put it in place. You can glue it, I soldered the rod ends to the cube. Do the same with the SHORTER rod and the switch piece. Put the t-shaped cylinder slider piece under the maze and glue the corners of the maze to the flat side of the cube. You can then glue on the ball on top.

Category: Mechanical Toys