Microsoft Surface cover clip

This Thing is licensed under the Creative Commons - Attribution - Non-Commercial - ShareAlike license. This means to share with other people you MUST give appropriate credit and a link to this page. YOU MAY NOT SELL this design, and if you remix this you must use the same license.

Sorry, I just want to make sure people follow the licenses :)

This is a clip that keeps the cover on the Microsoft Surface closed, instead of just that little flimsy rubber tie over the corner. Print in PETG or stronger because it warps over pressure and stress of being forced open, holding the cover closed.

Made in Tinkercad

Print Settings

Printer Brand:

Prusa

Printer: 

i3 MK3 MMU 2

Rafts:

No

Supports: 

No

Resolution:

15mm SPEED

Infill: 

100%

Filament: Overture PETG Black

Notes:

Print in PETG or stronger because it warps over pressure and stress of being forced open, holding the cover closed.

Category: Other