Ender 3 V3 SE Wyze V3 Camera mount

Youll have to go into the advanced settings and flip the camera image 180 degrees to be able to view it properly. Else it will be upside down. Use supports. V2 might be better than the V1, haven't printed the V2 though but V1 is very tight fit and its becomes pressure mounted. I also had to remove the rubber pads on the bottom of the camera but it works for me. Print it in whatever orientation works best for you.

I had a logitech C720 and had printed the original mount. Also did a remixed for it where the arm was moved to the top instead of the bottom but it didn't fit my needs due to relocating the LCD screen for a cleaner look.  Bought s wyze camera and it was attached to the LCD with a different print but I didn't like the stationary aspect. Thus I decided to remix this one. Its little hard to print and you will need supports. The original one is a pretty tight fit. I had to remove the rubber bad on the bottom of the camera to make it fit in and it become pressure fitted. I decided to shave another .5mm off the camera holding part to see if its better and wont require removing the rubber feet. I have not printed the V2 version myself as the original fits my needs but I figured it would be a good idea to provide. Let me if it works well if you decide to print V2