G-tube for Teddy Bear (EDUCATION)

Remix of the MIC-KEY low profiled g-tube design from Lurie Children's Hospital.

Tips:

• You can do the print without supports but using supports comes out better. I used the same TPU materials as the supports and comes off pretty easy if you can something to grab them. 

• I superglued the second peice into the main g-tube portion and then stitched the doll after g-tube is in place. I've put on the whole print together including the stopper (spiked part) on first then stitched the doll. Doing this is much easier. 

• I've usually make a horizontal (small) cut across then superglue the second piece perpendicular to the cut and then stitch the cut closed to hold the g-tube in more securly. 

Made it so you're able to close the flap of the g-tube.