Lidded box for 6th gen VW Polo central tunnel

A small box sized to fit the squared hole in the vw polo 6th series central tunnel, done mostly for places where leaving exposed change in the car can cost a window.

The lid hinges on two couples of 1cm (diameter) by 1mm (thickness) magnets because i had a lot of those around and the hinges i printed in the past tended to wear out easily if used often.

I printed in pla and while writing this i'm not yet sure if it will tolerate well the summer heat inside the car or not.

5% infill is enough, it printed fine for me without supports.