Pegboard mount for Steam Deck

This is a simple pegboard mount for your Steam Deck.

My pegboard has holes that are 7mm diameter and spaced 1 inch (25.4mm) apart.

The brackets are designed to fit the steam deck in between the hand grips (see photos). You need to print at least two brackets, but you could use more if you wanted to provide more support.

Use this design at your own risk! I am not responsible for damage to your Steam Deck.

Print notes:

• Brackets should be printed on their sides. You need supports for the pegs, but this is otherwise a very straightforward print that didn't give me any trouble.
• I used 3 walls and 40% gyroid infill in order to strengthen the pegs as much as possible.
• Layer height doesn't matter, so I went with .3mm to increase the print speed.