I have several hooks / coat hangers in my house of the same type – one central upper hook and two smaller lower hooks. On two of them the central one broke the last years, and this week one broke completely by also loosing the lower hooks. As I didn't install them, and they seemed quite old, I tried to replace them with this model. One of the pictures shows my model in comparison with the other installed hooks.
The size is approximately 160 mm height, 60 mm width (max width) and about 70 mm depth. The holes are 4mm and there is a chamfer of 2mm for the screw heads. The distance between the holes is 20 mm.
I printed those in a standing position, and I chose a 0.2 mm Strength Profile (Bambu Lab, 5 perimeters), with gyroid infill (25%). I printed in white PETG and support was not necessary. Print came out quite good, stability seems fine. Print time is 2h 45m for two of them.
The author marked this model as their own original creation.