RaspberryPi 3 case, no screws Extrusion Mount w/40mm Fan

I loved the original snap together design, but wanted to add a fan to help with the heat. So I made the top of the case taller which allows for a 40x10 fan. Also cut a hole to expose the gpio pins to allow for DLSR time lapse snapshots. Cut out a rear hole for a ribbon cable for a PI Camera. Lastly, added an extrusion profile to allow it the case to slide into an extruded aluminum frame.

This top piece matches the bottom which can be downloaded here:
https://cdn.thingiverse.com/assets/69/49/63/54/f4/rpi3\_notft\_bottom\_2016\_12\_09\_1000.stl

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

No

Supports:

No

.20

Filament: Duramic3D PLA+ Any