PiCamera V1.3 enclosure with slot

Remix of ( https://www.thingiverse.com/thing:2772725 )

Made a bracket that holds the camera in place by sliding into slot instead of requiring back plate with zip tie. Made this to work with PiCam V1.3.. should work with V2 but not sure. I basically took the bracket from https://www.thingiverse.com/thing:1831042 and the mounting legs from Petclaud's model, combined them and added the slot to slide in the camera pcb. Fyi if someone wants the modify the slot, the thickness of the circuit board is 0.85mm according to my digital calipers.

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Rafts:

No

Supports: 

No

Resolution:

0.15mm

Filament: MIKA3D PLA red 
 

Notes: 

Depending on printer, tolerances and quality of print, may require slot enlargement. I used a thin file to smooth out slot where camera slides in.

Category: 3D Printer Accessories