Trim Lip for Simple Mason Jar Candy Dispenser

@CarlBelcher's Simple Mason Jar Candy Machine is a great, and very functional novelty. This little piece is a quick print that adds a little height to the bowl on the bottom, so Skittles and M&Ms stay in the bowl, and don't go shooting out onto the table or floor. Simple print, takes about 20 minutes on my Ender 3 Pro/Sonic Pad combo. No supports or brim should be needed. 

I print it with the crank and pin, and glue it in place after the main body is printed. I use Gorilla Super Glue. 0.2mm height, 2 walls and 15% in-fill, which are the same settings I use for the main candy dispenser.

@CarlBelcher's Simple Mason Jar Candy Machine is a great, and very functional novelty. This little piece is a quick print that adds a little height to the bowl on the bottom, so Skittles and M&Ms stay in the bowl, and don't go shooting out onto the table or floor.