RCT715 Cargo Rack Mount

I would suggest printing in PETG, and a minimum of 4 perimeters.

You will need minimal supports to support the overhangs. I like organic, but that is up to you.

You will also need two M5 machine screws and either (1) two heat-set inserts, or (2) M5 two nuts. If you use nuts, the screw needs to exceed 16mm, and if you use heat-set inserts, you should use 16mm.

You will need to disassemble the stock mount, and use the latching portion. In order to install this, you'll need two more machine screws of M2 size.