Improved Garmin GPS mount - USB type for Skoda Citigo, VW Up and SEAT Mi

This is version 2 of the Garmin GPS mount for the later type fitting in the 2017 Citigo, Up and Mi which have a USB socket under the base. The neck has as a 17.4mm radius ball to match the standard socket on Garmin GPS brackets. It should be tall enough to take up to 6" satnavs. This new design has an upgraded version of the clever spring clip design from XenoBlaster and is a much more stable fit than my earlier version.

For extra security print two of the fillers (mirror one of them in the slicer). Press them into the spaces at the side of the mount after it is in place to lock the tabs out.

Print Settings

Printer Brand:

Prusa

Printer:

Mk2.5s

No

Supports:

Yes

Not important, 0.15 and 0.2 OK

Infill:

20% Not critical

Notes:

I suggest at least four perimeters to get good strength.The ball may need a bit of sanding depending on how well dialed in you have the support interface but don't remove too much as it needs to be a tight fit.