REVISED!!! LED Light Mount for Ender 3 V3 KE

4/12/2024: REVISE #2

My initial design did not hold up for very long and a couple bumps with my hands when changing filament finally took it out for good. I decided I needed something beefier but wanted to stick with PLA as I already had things going with the yellow.

I beefed them up considerably, they bolt on now using your existing gantry hardware. Just remove the 3 bolts, then fasten them on using them in the original holes. Works GREAT!!!!

4-1-2024: REVISED due to noticing a little bit of sag because these lights are a bit on the heavier side for LED's. Added a small little clip on the rear leg and the problem is gone.

I have seen many light bracket mounts for Enders, however, nothing to fit these LED Motion Activated lights I purchased on Amazon. These clip the light tightly and fit the gantry cross member very securely.

Set the motion sensor and you have light anytime your machine is moving and shuts off when idle.

If you have these Auxoda LED lights then, these are the brackets for you.

https://a.co/d/bPiUoWW