Sponge Holder

Requires minimum support for the SpongeHolderBottom part. The Spongeholder Part can be printed as is and test fitted around your sink. Afterwards with the help of a heat source it can be bent to perfectly fit your sink. Following this,  slide from the top and press fit the SpongeHolderBottom Part on the bent part already on your sink. Finally fit the _encaje part onto the bottom and add a rubber band to the back for more stability (optional, see picture). 

The Infill I tested was 15% and it worked perfectly. It fits perfectly when printed with PLA on my Bambu Labs P1P on the highest layer height, which means it should fit even better with lower layer heights.