Enclosure spool hanger and smoothly rotating spool presser bar

It was created to be installed inside an enclosure to smoothly send out soft filament.
Since the height cannot be secured, it is for small crafts.

Spool hanger for inside enclosures and spool presser bar available for many inside diameters.

Spools with an inner diameter of 45Φ to 80Φ and a width of 45Φ to 115Φ can be used.

M3 10mm bolts and nuts for the spool hanger.

For the spool presser bar, use two skateboard bearings, one M8 20cm or larger bolt and four nuts.