These brackets can be mounted to the top of your Lack Enclosure, allowing you to place your Sunlu S2 dryer on top and open the enclosure lid without the dryer falling off!
You will need to print 2 of these, one mirrored.
They can be mounted to the enclosure using the same screws that were required for the legs, hinge components etc. (pan head screw, 5×20 mm, QTY 4).
To position the brackets you can use the dryer to space them correctly. Or refer to the sketch.
I printed these in PLA, 0.35 layer height, 20% infill.
The author marked this model as their own original creation.