This is a soldering air filter that you can make with an old 120x120mm pc fan. The power consumption is very low (12v 0.09amp for 1.08w) and the fan is very quiet if you use the same as mine.
For this project you will need :
4x M3 threaded inserts (max 6.5mm deep)
4x M3 screws with a length of about 7-8mm
4x M2 threaded inserts (max 19.5mm deep)
4x M2 screws with a length of about 10mm
1x 120x120mm square of carbon filter (just cut a piece)
1x old 120x120mm old computer fan or a new one
1x switch
1x 12v jack connector
1x 12v power supply (you realy don't need a big amount of apms, 1-2amps is fine)
1x each 3d printed parts
Assembly instructions :
If you don't have all the parts :
Happy printing!
The author marked this model as their own original creation.