Mini pottery wheel magnetic sanding adapter 10cm

This adapter is for mini pottery wheels with 10cm diameter. You will have 9cm diameter left to sand.
2
23
0
299
updated March 28, 2024

Description

PDF

This adapter is for mini pottery wheels with 10cm diameter. You will have 9cm diameter left to sand. The rest is used for clamping the disc down.

Parts needed:

  • 2 M3x12mm screws
  • 2 M3 nuts
  • 12 8mm x 3mm magnets
  • 10cm acrylic/glass discs

Assembly:

  • Put the magnets in the holes and either glue them in with hot glue, or put some tape over the holes.
  • (You might have to sand down the sides of Base_A and Base_B for a tighter fit.)
  • Place Base_A and Base_B on your pottery wheel and connect them using the screws. Make sure they fit tightly, by trying to pull them off the wheel. If you can't pull them off easily, you have a good fit.
  • Place a 10cm acrylic disc in the middle of the 2 bases and the sanding paper on top.
  • Push the Clamp_Ring on the acrylic disc. Everything should be held down by the magnets.

Happy sanding

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

0.28mm

Infill:

20%

Filament: Generic PLA Yellow


Notes:

Supports are not needed. I used 20% Infill because it barely makes any difference, but 10% will probably also be fine.

Category: DIY

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License