SAE connector cap with wire keeper - EASY TPU

If you use SAE quick disconnect connectors as part of electrical connections on boats or RV's and want to add protective caps that slip-on or slip-off and hold themselves in place on the wires they are attached to, you 'll want to use this pattern.

Prevent accidental shorts, spiders and dirt from clogging your electrical connections.

Print these in a TPU profile that matches your favorite TPU.   Set perimeters to 3 and you'll get a nice rubbery connector cap with wire keeper.  No supports required.  I recommend TPU because the tolerances will be tight, and TPU will be flexible enough to get the job done, and the wire keeper will be nice and rubbery.

Print a pair for each SAE connector you are using, one for each side when the wires are disconnected.