REMIX: Best Nozzle Wiper / Abstreifer Bambu P1/X1

Full credits go to the original designer of this great alterantive nozzle wiper.
15
138
3
902
updated March 28, 2024

Description

PDF

My Print Settings. Print in Z Direction as shown in picture! NO supports required!

  • PLA
  • 04. Nozzle
  • 0.12 mm Layerheight
  • Infill: 15% Gyroid
  • Seam:back
  • 2 perimeters

Tags



Model origin

The author remixed this model.

Differences of the remix compared to the original

I print a lot of PETG with color changes and from time to time the nozzle captures alot of PETG which is then drawn into the print causing issues. Sven's nozzle wiper does a great job to clear the filament off in most cases. 

I'm new to Silicon casting and had issue getting bubble free casts. I played around with the step model and designed an alternative mold form. A syringe is not required for this mold. Simply screw together the mold parts with M3 screw and overdrive it so that you can secure it with a nut.

Just let the silicone run(slowly) into the mold. One funnel is for filling, the air escapes from the other. It's best to simply fill up the right funnel, wait a moment and tap the mold down to the table a few times and fill it up again unti its leveling out with the other funnel.  Then just let it dry, open it and cut off the excess.

I did not modify the carrier, please download from original post.

 

Disclaimer: use at your own risk, I'm not responsible of any issues this cause with your prints and/or the printer

 

License