Ender 2 Pro KlipperScreen and Pi Zero Mount

I used PLA+, Raspberry Pi Zero 2W and a waveshare 3.5in IPS Touch display.

Power comes from the 24v supply on the printer and uses a buck convertor to step down to 5v to a usb cable to the Pi Zero. Then a USB to the printer for Control.

I also added an Arducam 12mp Autofocus camera using the Pi Camera port.

https://www.printables.com/model/823350-ender-2-pro-camera-mount-for-arducam

!!!Below is from the Original!!!

This is a "KlipperScreen Box" for the Ender 2 Pro to replace the stock display. The box can be inserted and fixed to the printer's original mounting holes. The Raspberry Pi (2) Zero and the Raspberry Pi 3.5" LCD touchscreen are mounted together into the box. The whole thing is connected via a serial connection to the mainboard, which is also used to provide the power supply. I recommend paying attention of using an "IPS" display so that the widest viewing angle is guaranteed – a high value of FPS is not important for the intended use.

For the assembly you need:

• 1x Raspberry Pi (2) Zero

• 1x Raspberry Pi 3.5" LCD touch screen

• 6x M2x6 screws

• 6x M3x5 screws

Assembly: Screw the Rapsberry Pi Zero onto its mounting plate (4x M3x5). Place the touch screen upside down into the frame and screw the back cover onto the back of the frame and touch screen with 2x M2x6 screws. Then put the two parts of the box (frame & mounting plate) together and screw it with 4x M2x6 screws. Finally, insert the bracket and fasten it with 2x M3x5 screws.

Important: The standoffs for the touch screen have small gaps - so please insert some pieces of foam between the standoffs and the touch screen.

Tinkercad Project: https://www.tinkercad.com/things/2piaqWIEdQY

I extended the mount and added passthroughs for the USB ports on the Pi Zero 2W. This allows the cables to clear the base of the printer.