Honeycomb/Logitech bracket for mounting the Octavi IFR-1:
Got an Octavi IFR-1 but need a mount for it? This screws to the Honeycomb/Logitech mounting systems useing the existing screws. You can then sit your Octavi upright in front of you. Also fits a streamdeck or mobile phone. The pictures show that I have an Octavi and streamdeck mounted on 2 brackets at either end of my Honeycomb Alpha.
Please visit my site: Makers Point to see if anything else interests you.
Print Settings:
I printed this in PLA and if you print in the same orientation shown in the 3mf file, no supports are needed. It prints in one piece so no assembly is required. It takes about 3 hours on my Prusa MK3S at 0.2mm layer height.
Tips:
Use a bit of velcro or thick double sided tape to hold your device on the bracket. This just stops your device moving left and right.
The author marked this model as their own original creation.