So much nicer to load batteries. Well Done
So much nicer to load batteries. Well Done
@KostasZ_9678 Howdy, hopee your well. If you dont have time. would you be willing to share the Fusion or othere format raaw file, reming the STL for the canopy pegs as per my picturees isnt going too well.
@DruiD_1343766 Ahh superstar!! Thx
@KostasZ_9678 Hopefully this helps- I am trying to
A) reduce the overlap distance on the rear chassiss screw point - abnout 0.5 mm each side
B) increase the width of the front chassis screw point - about 1mm each side
c) add 'locating' pegs (basically a little circle ridge) that will slide inside canopy locating column pillar things - also adding strength.
Not sure if I have a newer canopy design or why its different butt this kit is about 4 montths old. (edited)
Hi @KostasZ_9678 -Thanks so much for combining and posting this. I was using the seperate battery mod but after a recent crash wheree it pulled the screwss out of this chassis piece, I upgraded to your design. One question, when I mounted this - the rear strengthened tabs pushed the top canopy about 1.25 mm proud on each side - causing the lower canopy not to line up. I have "sliced" vertically off about 1.27mm each side and that fits more snug and "lines up" with the bottom canopy.
Did you find this at all? I have few weeke old \ new kit S2 - so not sure if they changed the canopy mounting or moulds have chaanged slighly etc. but its enough to cause canopy closure issues.
@KostasZ_9678 No not exteend, shorten - reduce, the rear "standoffs" for me are too thick pushing the top canopy screew posts outwards - see this pic where I havve drawn the line.. reducing the thickneess of these "lugs" - otherewise thank you so much foir posting this!
If you have a look at the 2nd photo, the original design as circular "pegs" these fit inside the canopy mount just slighly, helps align the canopy on.
Your design is great and thicker, but as its flat\square top - it cannot fit "inside" and thus pushes the top canopy further outwards.
Unless your canopy \ design is different on the S2 - it should clearly be visible - the two sides \ top and bottom sides of the "mouth"
dont line up perfectly. (edited)
@KostasZ_9678 Any thoughts on the circular vs square peg bit?
I crasshed yesterday and need to reprint, so mayt just trim witth an exacto as I have tried to remix and failed miserably lol