Simagic Haptic Reactor (HPR) mount for Heusinkveld Sprint brake

Additional parts needed: 4 M3x12mm screws (a little bit shorter or longer should also work)

Print the mount and 2x each washer. Use 3 perimeters and 25% infill.
Then mount the reactor the mount first with the included M4 screws. After that you can mount it to the pedal by using the M3 screws and the washer. The M3 screws will thread into the plastic holes.
Use the smaller washer for the top hole and the bigger washer for the bottom hole. Don't overtighten, but tighten until the play is gone.

This mount is for the brake only, but I'll try to make one for the throttle as well in the coming days.