6 Piece Small Vise

This is  simple Small Vise that does not need any metal bolts  :)

I was inspired by this print a while ago

https://www.printables.com/model/53471

And wanted to make one that was a little larger and did not need any metal bolts/nuts.

If you are going to print this I suggest you do 3 Perimeters and set it to 40%+ infill and use gyroid infill

Also you may need to put a little grease on the enclosed axle.  I just put a little bit on each side and worked it in and it stopped all the squeaking I was getting :)