Knomi 2 Stealburner HEX Burst Pattern

I used the same specifications via Voron Design group of:

0.04mm Nozzle

Adjust all print settings to 0.04mm for 1st layer and beyond. No inflated tolerance. It maybe more beneficial to go a little lower for 1st later to avoid elephants foot. 

5 top layers, 5 bottom, and 4 outlines… though the model may not be that thick, I just stick with these settings. 

I printed the pieces out of ASA / ABS

Just adds another visual variant to the HEX patterns that are available for the Knomi V2 stealthburner toolhead. Thee only thing altered in this was merely ascetic. All original works can be found at the github link provided. The link will also include the retaining clip to hold the Knomi face in place which is required for the upgrade. 

Hope you enjoy