Print flat and assemble this D20 die. About 5-6 inches when complete. Should be able to scale each piece for bigger or smaller die.

Assemble all but 5 sides, glue through opening, I used P2-10 and activator. Assemble remaining 5 parts and glue. See photo of assembly. Will snap together once fairy lights inserted into die.

If you want to make permanent (non-openable), follow the same directions and then glue two pieces together.

For assembly, place assembled halves on the table (open side down) and press together. Then glue.

See link for assembly order: https://images.app.goo.gl/yUpEkG9gq5Bqa8TLA

Fairy lights I used: https://a.co/d/iVXU2hB

like this? Buy me a coffee: