Cat Vase Waterproof

A cute cat-shaped vase, capable of containing water 💧🌼, tested for over 48 hours.

Scaling

In the print profile the vase is 12cm tall, you can decide to increase or decrease the size.

Print settings

Brim is enabled but if you have excellent adhesion to the print bed, you can disable it. I printed using PLA Matte - Desert Tan, but you can use PLA Basic without any issues or waterproof problems.

Post-print suggestions

If you decide to keep the brimenabled, you will have to remove the brim after printing: I use this tool which makes the task easier and precise. If you notice the object becoming discolored where the brim was present, a brief burst from a hair dryer or heat gun can help re-melt the filament just enough to restore its original color. Be careful not to overheat, as this can cause the strands to melt together, resulting in a messy outcome.

Commercial license

Do you want to sell prints of my models? You can purchase commercial licensing by joining the Commercial License in my Patreon.