This is a u-bolt pole mounting saddle for this U-bolt set:
https://www.amazon.ca/uxcell-Round-U-Bolt-Length-Washer/dp/B093SR345L
https://www.amazon.com/uxcell-Round-U-Bolt-Length-Washer/dp/B093SR345L
Made to enhance the Carlon Meshtastic enclosure solution found here:
https://www.printables.com/model/804726-carlon-meshtastic-mounting-solution
It should fit pipes/poles with an outer diameter of up to 2", and give more rigidity when mounting the u-bolt plates against the poles, rather than relying on a small point of contact.
You will need to print 2 of them.
Material: PETG/ASA/ABS if using outdoors.
Infill: 25% Honeycomb (Tri-Hexagon)
Layer Height: 0.2mm
The author marked this model as their own original creation.