Slim Ender 3 V3 SE Dual 4010 Shroud K1 Edition

The new slim K1 shroud now supports my improved fan ducts (finally managed to learn how to do that).

Print the ducts in PETG, ABS or ASA. The shroud can be printed in what you want, maybe not flexible filaments :)

Uses the same instructions as https://www.printables.com/model/619049-ender-3-v3-se-dual-4010-shroud however when you print it, align the model face down like this without support; Then the new ducts get printed on the face where the outlet is, like this (you may need supports and a brim for this print);

Auto align should do this for you in Orca slicer but I haven't tested on others

YOU WILL NEED AN EXTENDED CR TOUCH CABLE! 10CM IS FINE