Animatronic Tail Gen 1.0 V2

This is a finished version of the Tail Gen 1

How to assemble?

What you'll need:

1. Some sort of thick multi-core wire (for the core). Something similar to “Stainless-Galvanized-Aircraft-Balusters-Handrail” 
   Note: Use a vinyl-coated wire, It will make your life much easier. 
   The wire should be 5mm thick (about 0,20 inches) and should be 83 cm (about 32,6 inches) long. 
    
2. Pulling wire(s). I used a 3mm (about 0,12inch) thick multi-core flexible wire, tho I can't find any similar wires now. You'll need two of them and they should be around 120 cm (about 47,2 inches) long but this is my estimate so take this with a grain of salt. 
    
3. Servos. You'll need two of them, and make sure that they're strong and they have metal teeth, I accidentally annihilated one (now, four of them) of my servos because it was too weak. I reccomend using some stron servos like 60kg ones.
    
4. RPI Pico. 
    
5. 4M screws.

Use the F3d File as your guide on how to assemble this.

Category: Fashion