HSW Deburring tool tip holder

This is a holder for 15 x Deburring tool heads for the Honeycomb Storage wall. I could not quite find a holder where my tips would not fall through. The only other version I found had too wide of a hole and everything was falling through. So the way I solved it is by creating a custom version holder for Deburring heads. They will never fall through as the hole ends in a solid layer.

The design will fit inside the Honeycomb Storage wall without any mounts or caps, should just nicely(maybe slightly tightly) fit the Honeycomb Storage Wall. There is an expected gap of 2mm from the wall on the pegs with which you connect the holder to the wall, so don't force it inside more than needed.

The tolerances are designed so that the holder is printed from PLA and should then fit snugly into the Storage Wall printed from PETG. If you have any issues or if the fit is too lose let me know, I will redesign this for you. Including a step file just in case. My Prusa MK4 can nicely handle the tolerances, but it can vary from printer to printer and plastic so looking for feedback.

No supports needed, 15% infill is fine, PLA, 0.15 layer height (that's what i used)

Created a new holder for the Honeycomb storage wall.