Hyundai Ioniq 5 mobile phone mount.

Cell phone mount for door side panel on the dashboard. Angled towards the driver, but not adjustable. Made for the Pixel 6a, but should fit any type of similar size.

Slider is held in place by a rubber band on the back (will probably have to be replaced once in a while)

The mount, https://www.thingiverse.com/thing:5629969, is used as is.

The baseplate, https://www.thingiverse.com/thing:5624566, is cut to make the left part slide.  (couldn't link to both models in in the upload interface, probably because of differing licences)

Imported both into Fusion360 to modify and combine them.

Printing instructions:
Material: Petg or better (pla will probable be too soft in direct sunlight)
Layer height: 0.2
Print the base sideways with tree support. See screenshot of Cura.