A simple case for the DASBOB keyboard
A bottom keyboard case to fit a DASBOB keyboard--a 36 key split ergonomic keyboard.
23
90
1
907
updated
June 18, 2024
Description
PDFThe case is a snug fit, with only 0.2mm offset from the DASBOB PCB.
- Layer height: 0.2mm or less
- Filament: PLA or PETG
Required parts
- M2 * 4mm GB823 screws
- M2 * 2mm (height) * 3.5mm (OD) brass heat set threaded inserts
This model was a learning exercise, as I begin developing my 3D modeling skills. I welcome and appreciate any feedback or suggestions.
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
This model was heavily inspired by @beekeeb's minimal dasbob case, but with the following adjustments:
- Slightly thicker base (2mm) for rigidity
- Bottom Insets for 8mm diameter bumpons--to keep them in place, and to reduce placement decisions
- Wider screw (M2 * 4mm) mounts
Updated: A tenting model has been added which provides a 20 degree tenting angle to improve ergonomics. The case fits snugly into insets of this tenting platform. Best printed vertically to save material and print quickly. Any layer height should work, photos are with 0.25mm layer height.