MJX Hyper Go 16207 spoiler

I have an MJX Hyper Go 16207. It is a wonderful cheap RC car and is too fast for its own good when used with the included 3S lipo battery. Fast enough to flip over often and damage the rear spoiler and the wheelie bar. 

In my case the spoiler was broken into several pieces and the wheelie bar ovaled out its mounting holes. So I designed this very blocky replacement spoiler with a little trunk on it to interface with the existing holes in the wheelie bar. The wheelie bar supports the back of the spoiler and the spoiler prevents the wheelie bar from twisting or moving left/right. 

I would suggest that you print this with weak settings (low bottom/top/wall count, minimal infill) so that it breaks before parts that might be more difficult to replace.