Above Eye Level Continuity Camera Mount

I needed a way to hold my iPhone for use in the Continuity Camera feature. However, my setup doesn't allow me to put something on the monitor. Therefore, I designed this to slot in under a pull drawer on my desk. This allows me to not only use the feature, but also have the camera angled slightly down, giving me better lighting.

I suggest printing this on its side. That will increase the strength at all of the joints significantly, because there will not be any layer lines along the joints.

I designed this for an iPhone 14 Pro with a fairly slim case on it.

I included the f3d file from Fusion 360 if someone wanted to make tweaks for their own setup.