Rivian R1S and R1T Lower Console Trash bin fits into Yee Pin lower console organizer. Note: as of 3/25 the organizer is "not currently available on Amazon"

Wanted a good and stable trash can in the front of my R1S. Bought the Yee Pin lower console organizer from Amazon to hold and stabilize it in place under the dash.

https://www.amazon.com/gp/product/B0C744L1G5/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Prtinted in two parts PTEG. These are very long prints. Prepare to start a new roll of filament with each part.  Fits very snugly in the console organizer--Might just take out the entire organizer with bin to empty the trash.

Printed the top in adaptive cubic and adjusted the supports for easy clean up, still required a bit of trimming. Upside down worked best for me, an upright print failed 20 hours in.

Supports for the bottom half were warped as the print went through, but it completed. I have included the STL file so you can play/remix. If I did this again I might do adaptive cubic on the lower half too .

YMMV