Corner protection

Print Stettings:

• 2 walls
• 15% Gyroid-Infill
• 0.3 mm Layer height
• 0.4 mm Nozzle

Put it down with the big flat surface on the printbed. This is the upper side of the part.
I printed on the textured PEI bed, which I prepared with a touch of glue stick.

Material:

• eSun TPE 83A Shore 

Because of the hollow structure and the soft rubber material you get a very squishy bumper which will protect your door from getting damaged, even if you hit the door really hard against this buffer.

Dimensions are 35x35x35 mm - with a 12 mm thick cushion.