HelTec LoRa 32 V3 Holder

This holder allows you to put your Heltec anywhere you want and inside any enclosure you choose. Just use either superglue, double sided tape or even velcro?

Just feed the battery plug through the bottom hole at the back and plug it into your board. Then slide the Heltec into the slots, push it all the way in. It will be a snug fit on purpose!

For best results print this upright as shown in picture 2. 

Print settings are: 
15% infill
0.2 Layer height
Support Enforcers Only at the base if you wish.