Dachshound Paper Towel Holder

Dachshund Paper Towel Holder designed by anjilus. Remixed to be easier to print and fit in a build area under 180mm.

Printed with tree supports. I printed the top and bottom sections at 0.2 layer height and the middle section at 0.28 with a 0.4 nozzle. 

Split the model from 2 pieces into 4 pieces which are pegged. This allows you to print in the model in a build area less than 180mm tall. Original model by Anjilus was nearly impossible to print without alot of supports and would not fit in a 250mm tall build area.