Meshtastic Router Base and Solar Bracket

This model is designed for easy assembly of a plastic enclosure with Meshtastic electronics and a small 4.5W solar panel onto a 34 mm diameter antenna bracket. All models except one can be printed without supports. The "Base&Solar-Top" model requires supports. The provided 3MF files already have the correct orientation and recommended settings.

The bracket is intended for the ABB00846 enclosure with dimensions of 100×100×50mm and mounting hole spacing of 74.1×74.1 mm (affiliate Amazon.de, Farnell, TME.eu). However, the bracket can be used for any enclosure; you just need to drill mounting holes with the correct spacing. A dimension drawing is included among the images of this project.

The solar panel frame is designed for a panel sized 165×165×3mm, specifically a 6V/4.5W type (affiliate Amazon.de, Czech eshop).

I recommend printing with ASA material, which is UV-resistant and can withstand higher temperatures. If you don't have ASA filament, you can check out my other project, MakerDeals.eu. This website makes it easier to find, filter, and compare filaments available on Amazon.

The following non-printable components are needed to assemble the enclosure bracket:

• 4× M3 threaded inserts (affiliate Amazon.de)
• 4× M3×30 DIN912 screws
• 4× M3 washers
• 4× 3.5×10 DIN7981C self-tapping screws (for securing the base to the electronics box)

The following non-printable components are needed to assemble the solar panel bracket:

• 4× M3 threaded inserts (affiliate Amazon.de)
• 4× M3×30 DIN912 screws
• 4× M3 washers
• 12× M3×8 DIN912 screws
• 2× 3.5×10 DIN7981C self-tapping screws (for connecting the base to the arm)
• Silicone sealant to seal gaps between the frame and the solar panel

Do not hesitate to ask any questions. I can make a different mounting diameter if you have a different antenna bracket.