Nintendo 64 Cartridge Tray

This is a nice compact way to hold Nintendo 64 cartridges.

I've printed the 1, 2, 4, 6, 8, and 10 “cart trays with hole” variant.  The following is a photo including some of the earlier prototypes that I started with.

Recommended print parameters

• 0.1 mm (or less) layer height.  You can use a layer height greater than 0.1 mm but the tapering at the bottom won't be as smooth.  The following photo shows the bottom taper printed at 0.1mm layer height.

Note

This is the first model I've uploaded so if you are going to print this I would suggest printing a 1 Cart version to confirm the fit.