Artillery Sidewinder X3 Plus BTT-Pi drawer insert

I made this for running Klipper firmware on my X3 Plus using the Bigtreetech BTT Pi (https://shrsl.com/422y4). There's a small cutaway on the bottom for an HDMI cable (Left angle https://amzn.to/3wXwkN4) to run to an HDMI5 (or HDMI7) screen mounted in the original location of the stock screen (per photo). This mount exposes all of the USB and Ethernet ports for easy access to connect webcams, other printers, etc. 

Printed using Sunlu Elite PETG https://amzn.to/3vmpyjK. No supports, 5-10% infill. You'll need short screws to secure the board to the platter. Insert the left side first, then snap in the right side. It's a hair flimsy, so pulling on it to remove a USB cable requires a little stability with your thumb, but how often are you really going to remove the USB cables, amirite?