Gagguino Front Mount Gen 3 Angled Screen

Front screen mount for Gaggiuino Gen 3, with optional indicator lenses. SD card is directly accessible from the bottom of the mount.

Model is recommended to be printed in PETG with supports. Indicator lenses need to be printed in clear resin and pushed in from the back of the print.

Route wires as shown in photo and table to the back of the screen board. Screen slots into place and is held by 2x M3x5mm screws. The screws are directly threaded into the plastic, screw down until screen is flush but be careful not to overtighten as may bulge the bezel( a small gap between PCB is ok).

The screen wires are fed thru the middle indicator lens that is removed. The mount is held in using the original switches for the machine.