Power supply cover. Ender 3 v3 SE

To reduce the noise from the fan in the power supply, I painted my cover. The noise level has decreased by 10 decibels. 

Additionally, I set the Thermistor to 50 degrees, now the fan turns on only when the temperature rises. 

Mounting on 4 small screws. Additionally, symbols on the cover are displayed in the layout so as not to confuse them. 

The installation is simple - Disconnect the power cord! Unscrew the 4 screws on top of the table. There are 8 small screws on the bottom. Disconnect the wires from the power supply and remove the 4 screws along the edges (one screw under the sticker). Assembly in reverse order.