Do you have any advice for printing the Base. Every time I try it starts wobbling, even at 50% speed and scaled down to 50% size. I'm only 1 week into 3d printing so any pointers would be greatly appreciated.
Alastors staff
This is a 113 cm long staff i designed for FACTS (Belgium Comic-Con). I thought i'd share it with you.
22
205
0
1034
updated March 18, 2024
Makes
Comments
View 3 more comments
@JelleAvocado_1037900 I haven't found a printed way of getting the sticks to slip fit but I am trying to see if I can just change the part size percentage to go that direction. As of right now I'll likely just drill out the holes with my drill press on the bottom to fit into the bosses on top sides. These prints were done at 95% (base) 96% (middleone) and so on but it feels like if I start at 90% and go up 2% per part above that they should fit together better.
@RonnieBouley_1965019 Yeah, that's probably the best way to do it. I'm not that good at making things fit, but at least I tried.