Anycubic Kobra 2 Fan Shroud (no supports)

I just wanted a black and gold printer so I made some new printed parts. I also hate supports so I designed it to print without supports. If you want the corner braces in the photo then I have a separate page for that.

I can't remember the exact settings I used because I made this a while ago but I think it was along the lines of:

layer height: 0.2mm
walls: 2
wall order: inside to outside
infill type: cubic
infill density: 15%
top/bottom thickness: 1mm
 

make sure your retraction and flow settings are tuned so the screws for the fan shroud fit well.